Built to last these garden sheds look fantastic too beautifully crafted and finished to look at home in the most stylish of outdoor spaces.
Making a tongue and groove shed door.
Turn the door 90 degrees and cut it 1 2 inch smaller than the height of the opening.
The beauty of a tongue and groove shed is its versatility as these basic buildings can be transformed into various other uses.
Making a door from plain edge board means that gaps will appear between the boards dependent on the season of the year and the moisture content of the door.
The next step was to put glue in the groove on the board one board at a time and secure it into the tongue on the next board.
All our tongue and groove t g sheds are available in various sizes with choice of either a pent or apex roof design.
Tongue groove wooden garden sheds.
It might take some extra time to build this door type but it looks stunning when it s complete.
In regular board and batten it may develop gaps over time.
Tongue and groove sheds our premium tongue and groove sheds are constructed from interlocking boards to form a sturdy long lasting build.
Download the sketchup file.
Building a diagonal tongue and groove shed door this shed is sided with tongue and groove cedar and trimmed with azel pvc trim.
Pick up the panel and cut the tongue and groove panel parallel to the grain 1 2 inch smaller than the width of the opening.
Super sped up google sketch up design of my shed door followed by me putting it together.
Tongue and groove have many benefits one of which being that the boards are less likely to separate.
After the roof goes on the last part of the project is to make and install a tongue and groove door set.
Set a table saw to the width of the opening.
To make the sides of the door look like normal pieces of wood mike cut the groove off one board and the tongue off another board.
We laid these pieces on each end before we started gluing the boards together.
The instructions are a bit sparse.
If you are building a shed door out of the more commonly available tongue and groove boarding then you can omit this step.
Measure the door opening with a tape measure.